ProLevel Fibre: Reinforced Flexible Floor Leveller - 20kg
UltraTile ProLevel Fibre: Reinforced Flexible Floor Leveller is a single part, high strength, rapid drying and curing concrete floor leveller. This floor leveller incorporates a blend of specially graded fillers, cements, polymers and fibres. The specially formulated fibre technology aids application and strength resulting in a strong and even base which sets in 3 hours and can be tiled upon after 8 hours.
Application
When priming the substrate, please refer to the product data sheet.
Mixing ratios of powder and water should be controlled to ensure a free-flowing material suitable for a 3-75mm application.
For trowel/hand application, mix in a clean bucket using clean cold water, as warm water will significantly reduce the product's working time and may result in shrinkage. Pour 3.4 litres of water into an oversized bucket (20+ litres), and then gradually add the powder whilst mixing continually with an electric paddle mixer. Do not use excess water, as this will affect the product's performance and finish.
When all powder is added, mix for a further 2 minutes, keeping the mixer below the surface (to minimise air entrapment) until a lump-free creamy material is attained.
Once mixed, the product can be applied by pouring it onto the floor and spreading it with a smooth-edge steel trowel. Plan to begin at the furthest point working back towards the point of entry to avoid walking through the wet product. Maintain a wet edge to ensure adjacent mixes blend in correctly.
It may be beneficial to batten off areas into sections for large areas or deep sections. Keep free from floor traffic and other trades whilst curing.
Coverage Rates
| Applied Thickness |
Coverage Per Unit (approx.) |
Consumption Per 10m² |
| 3mm |
4.0m² |
2.5 bags |
| 5mm |
2.4m² |
4.2 bags |
| 10mm |
1.2m² |
8.4 bags |
| 15mm |
0.8m² |
12 bags |
Technical Data
| Depth |
3-75 mm |
| Working Time |
20-30 minutes |
| Set Time |
3 Hours (3 mm) |
| Tile After |
8 Hours (3 mm)
24 Hours (5-15 mm)
48 Hours (15-30 mm)
72 Hours (30-50 mm)
7 Days (50 mm+) |
All times depend on temperatures, substrate and site conditions.
Storage
This product must be stored in unopened bags, clear of the ground in dry conditions. Avoid frost. Ideal storage temperatures are between 5˚C and 25˚C.
Shelf Life
Under the above storage conditions this product has a shelf life of 8 months. High temperatures and high humidity will lead to a reduced shelf life.
