EWI-330 Mineral & Acrylic Primer

This deep-penetrating primer is designed for final preparation of surfaces prior to applying EWI Pro mineral, acrylic and mosaic renders. It strengthens the substrate, limits and balances its absorptive capacity without compromising breathability. It facilitates rendering plaster coats and enhances their adhesion to substrates. EWI-330 can be pigmented to match the colour of the render.

Application

Substrate Preparation: All substrates must have appropriate load-bearing capacity, be compact, stable, even, free of dust, grease, anti-adhesive agents, remaining paint, mould, algae, moss, etc., scratches and salt efflorescence and uniformly dry. All contamination resulting from grease, oil, anti-adhesive agents should be cleaned by washing with water containing detergent. The surface should be cleaned with a wire brush to avoid biological contamination. Scratched and cracked surfaces should be repaired with repair and patching mortar. Mortar applied to repaired sites should be dry and well-bonded. Highly absorptive and sandy substrates should be covered with EWI-301 and allowed to dry for at least 12 -24 hours prior to priming with EWI-330. Surfaces that will not be rendered should be protected prior to priming.

Product preparation: Mix thoroughly before use. The primer must not be thinned with water or mixed with any other materials.

Application: Apply EWI-330 primer uniformly to the substrate by painting method using a roller or brush and allow to dry. Render should be applied only after the primed surface is allowed to dry for 24 hours. Works must not be carried out at ambient temperatures below +5°C, works on elevations must not be carried out during rain or snow, strong winds and in direct sunlight, without special shields to limit exposure to weather conditions. Recently rendered coats must be protected against rain, frost and over-rapid drying.

Caution! The colour of the render primer may be slightly different from render colour itself when the same pigments are used.

Application Conditions

• Application temperature (air, substrate, materials): from +5°C to +25°C
• Coat drying time: approx. 4 hours
• Time to plastering: approx. 24 hours after priming
• Colour: white or another render-matching colour (recommended for render with scratch-effect finish)
• Quantity to be used: approx. 0.2-0.3 kg/m² (depending on substrate structure and absorbency)

Storage Conditions

21kg or 7kg plastic buckets

Shelf life: up to 12 months from the date of manufacture. Store in a cool dry place at a temperature ranging from +5°C to +25°C. Once open, keep the product sealed and in the original packaging.

Frequently Asked Question

1.       What is Mineral & Acrylic Primer used for?

Mineral & Acrylic Primer is designed to prepare surfaces before applying EWI Pro mineral, acrylic, and mosaic renders. It strengthens the substrate and limits and balances absorptive capacity without compromising breathability.

2.       What colours can I tint Mineral & Acrylic Primer to?

Mineral & Acrylic Primer is white, but it can be tinted to any colour to match the render finish. Please note: The colour of the render primer may differ slightly from the render itself when the same pigments are used.

3.       How do I apply Mineral & Acrylic Primer?

Mix thoroughly before use. The primer must not be thinned with water or mixed with other materials. Mineral & Acrylic Primer should be applied using a large paintbrush or roller, covering all areas of the substrate. 

4.       How long does Mineral & Acrylic Primer take to dry?

Mineral & Acrylic Primer takes approximately 4 hours to dry. However, it should be left for approximately 24 hours before work continues, such as plastering or rendering.

5.       How do I prepare the substrate before applying Mineral & Acrylic Primer?

Highly absorptive and sandy substrates should be covered with Water-Based Primer and allowed to dry for at least 12 -24 hours before priming with Mineral & Acrylic Primer.