Insulating Cork Render (EWI-745)
£19.99 Excl. VAT
- Heritage friendly
- Completely natural insulating render
- Eco-friendly
- Highly breathable
- Absorbs CO²
Please note that you may receive the product in either packaging.
Insulating Cork Render (EWI-745)
EWI-745 Lime and Cork Thermal Insulation Mortar is a sprayable coating mortar for the thermal insulation of both horizontal and vertical elements. Its spray machine compatibility lends itself to uniquely shaped architectural construction.
Intended Uses
Ceramics, thermo-clay, bricks, lime mortars, concrete blocks. It is not recommended for use on OSB panels. Rigid insulation systems are recommended for thicknesses greater than 8 cm. It is suitable for interior and exterior applications.
Substrate Preparation
Substrates must be solid, dry, and clean of any previous plaster, microorganisms, gypsum, cement, or other material that could prevent optimum adhesion. Dampen the substrate before application to ensure good adhesion and proper curing. This will also prevent dehydration and consequent cracking. For older substrates, it is recommended that a levelling parge coat is applied for uniformity.
Product Preparation
EWI-745 Lime and Cork Thermal Insulation Mortar comes as a 6kg dry mix. Mix 4.5L of water with the bag’s contents and continue mixing for 3-5 minutes until the mixture is homogeneous. For larger volumes of material, use an electric mixer on a lower speed. The usability after mixing is 60 minutes.
Application
Sprayed mortar: The mixed mortar should be spread evenly over the entire surface to be covered in layers of 1 to 3 cm thick. For thicknesses greater than 3 cm, apply the mortar in two or more layers, preferably before the previous one hardens.
Trowel-applied mortar: It is recommended that the mixed mortar be spread evenly over the entire surface to be covered in layers with a maximum thickness of 1 to 1.5 cm. For thicknesses greater than 1.5 cm, apply the mortar in two or more layers, preferably before the previous one hardens.
Storage Conditions
This product comes in powder form in a 6kg paper bag.
Use the product within one year of its manufacture. Store in its original, tightly sealed packaging in a cool place protected from rain. It is recommended that the entire bag be used once opened.
Weight | 6 kg |
---|
You may also like…
-
uPVC Stop Bead with Mesh (2.5m)
-
Silicone Paint Premium Bio (EWI-006) – 15 Litre
-
EWI Store – Rendering Tape – Orange 48mm x 50m
-
Silicone Paint (EWI-005) – 15 Litres
-
Lightweight Basecoat (EWI-269) – 25kg
-
uPVC Render Corner Bead – No Nose (2.5m)
-
Lime Basecoat NHL 5 (EWI-748) – 21kg
-
Mineral & Acrylic Primer (EWI-330) – 20kg
Reviews
There are no reviews yet.