Render carrier board tray designed to protect the bottom of the thin coat render systems installed on render carrier boards.
This item is made up of two parts:
The clip on profile sits on the front edge of the render carrier board tray and the 45 degree drip drives water away from the render system ensuring no water ingress.
Giving you a total of 10 linear metres of render carrier board tray.
This render carrier board tray is typically used for thin coat render systems. The render carrier board tray is attached to the bottom of the render carrier board and then the clip on profile is attached to the leading edge – allowing you to create a drip at the bottom of your render system.
The 6mm clip on profile clips on to the front of the tray and has a 45-degree drip profile, helping to drive water away from the render system to help limit water ingress.
The render carrier board tray is specifically designed for 6mm thin coat render systems and will fit all external façade boards with a thickness of 12mm. The tray is clipped on to the bottom of the render carrier boards at the same time as the boards are attached to the battens, so then they are locked in place.
The render carrier board tray is made from rigid PVC plastic, so there is zero risk of rusting.
The 45 degree drip on the front of the render carrier board tray also creates a clean finish at the bottom of the rendered surface.
The 6mm clip-on profile has rigid PVC plastic creating the 45-degree angle drip and 10cm of mesh that travels up the face of the insulation. The mesh is embedded within the basecoat of the thin coat render system, thereby tying the bead / tray to the render system.
The 45-degree drip ensures that any water travelling down the final render surface will not travel back under the render carrier board tray – instead the water is directed away from the render system completely.
The 45-degree drip on the front of the clip-on profile also creates a clean finish at the bottom of the rendered surface.
There are no reviews yet.